Assembly Mechanic-Composite Fabrication

Boeing•Berkeley, MO

7d•$24 - $31•Onsite

About The Position

Assembly Mechanic-Composite Fabrication Company: Boeing Defense, Space & Security (BDS) in St. Louis has a number of openings for Assembly Mechanic-Composite Fabrication to support our 777x Composite Team. Assembly Mechanic encompasses all of the duties of the following job classifications: Inspector Assembly, Sub-Assembly Precision, Mechanic Aircraft Production, Mechanic Electrical and Radio, Sheet Metal Assembler and Riveter. Individual job duties may include, but are not limited to: Composite Drilling Tooling Preparation Machine set up and operation Overhead crane operation Forklift and tug operation Assemble precision assemblies, set up and operate ream fixtures to drill, ream, countersink, spot face, hone and bore for mating major assemblies. Setup and operate shot peen equipment and accessories for stress relieving assemblies as required. Install press fit bushings and force fit bushings. File, fit, hone, ream, drill, tap, saw, burr and adjust. Assemble a variety of production aircraft and spacecraft parts and install aircraft equipment, support equipment or power plant equipment. Install, operationally check out, adjust, rig and pressure check systems. Perform bench and assembly line operational check out, troubleshooting, repair and adjustment of electrical and electronic systems, lighting circuits, power plant systems, wing fold circuits, missile launch racks, aircraft instrumentation, provide flight test instrumentation, fire wiring system, fuel system. Assemble, install, check out physical characteristics and modify wire bundles to aircraft of aircraft mock ups. Bench assemble electrical or electronic components and conductors into electrical units and systems before methods and procedures have been established. Cut, identify, strip, tin, solder, attach components, and pot to prepare wire for assembly. Tie, seal, and pack assembled bundles and units. Install wire bundles or other electrical and electronic components in aircraft, power plants or ground support equipment. Assemble aircraft and/or spacecraft structures or aircraft and/or spacecraft support equipment structures with or without the aid of jigs and fixtures by drilling, reaming, countersinking, stop countersinking, dimpling as assigned, burring, fastening, filing, filling, fitting, aligning, trimming, shimming and remove surface defects as assigned. Perform skilled assembly operations such as: shimming, fitting, trimming and aligning which may vary considerably from one assembly to another as with fairings and the mating of major assemblies; realigning or replacing ribs, bulkheads or stringers in skinned assemblies; establishing from blue-prints with or without firm callouts, butt, center, chord, station and water lines; blind pick up of hole locations for blank parts from existing structure; correcting cans, buckles, wrinkles in outer skins and remove surface defects as assigned. This position is expected to be 100% onsite. The selected candidate will be required to work onsite at one of the listed location option. Security Clearance and Export Control Requirements: This position must meet Export Control compliance requirements, therefore a “US Person” as defined by 22 C.F.R. § 120.15 is required. “US Person” includes US Citizen, lawful permanent resident, refugee, or asylee.

Requirements

1+ years of experience in manufacturing environment
1+ years of experience operating equipment where you need to continuously monitor the equipment to ensure it is operating correctly
1+ years of experience using hand tools and/or hand-held power tools