Assembler (Leads) - 1st Shift
About The Position
The lead assembler is responsible welding aluminum, copper, and also for hooking up leads on secondary and primary coils and accessories for single and three phase transformers. In this function, you will: Position and shape the leads for proper clearances within tank. MIG welds aluminum leads to bus bars, bus bars to stub-outs. TIG welds copper bus bars. Welds, glues, and crimps secondary leads to coil. Assembles and hooks up dual voltage switches, tap changers singularly or in gangs and other accessories required. Must take into consideration the positioning, clearances, etc., required for tanking. Fit, and cut braces for secondary and primary leads, including layout. Bolts onto core and coil frame. Measure and cut the leads to proper lengths. Measure, cut, strip, insulate and crimp terminals on other required leads. Does fabrication rework on cores & parts called for by NCR's and ECN's by engineering. Minor coil repair, as needed. Read Blueprints & Schematics.
Requirements
- High School Diploma or GED (General Education Degree) from an accredited institution is required
- All candidates considered must live within 50 miles of the Waukesha, WI facility. Active-Duty Military Service member candidates are exempt from the geographical area limitation.
- Ability to lift and carry up to 50 lbs. with or without reasonable accommodation
- Ability to work overtime when required
Nice To Haves
- Previous electrical experience or education in AC/DC
- Completion of Technical Diploma in welding from an accredited institution or equivalent experience
Responsibilities
- Position and shape the leads for proper clearances within tank
- MIG welds aluminum leads to bus bars, bus bars to stub-outs
- TIG welds copper bus bars
- Welds, glues, and crimps secondary leads to coil
- Assembles and hooks up dual voltage switches, tap changers singularly or in gangs and other accessories required
- Fit, and cut braces for secondary and primary leads, including layout
- Bolts onto core and coil frame
- Measure and cut the leads to proper lengths
- Measure, cut, strip, insulate and crimp terminals on other required leads
- Does fabrication rework on cores & parts called for by NCR's and ECN's by engineering
- Minor coil repair, as needed
- Read Blueprints & Schematics
Stand Out From the Crowd
Upload your resume and get instant feedback on how well it matches this job.
What This Job Offers
Job Type
Full-time
Career Level
Mid Level
Education Level
High school or GED
